Home > Ftp Error > Ftp Error B37 04

Ftp Error B37 04

Contents

Is your file much over 8 GB? Email check failed, please try again Sorry, your blog cannot share posts by email. %d bloggers like this: MVSFORUMS.comA Community of and for MVS Professionals FAQ Search Quick Manuals Register Profile McKown, John Re: FTP or SMS? You might take the output from the IEBCOPY and try to load it into another loadlib on the same mainframe.

When I pre-allocate the file on the mainframe side, the ftp changes the format from FB to VB and changes the record length as well, and gets a B37-04. Filezilla will not retry on 5xx errors. _________________### BEGIN SIGNATURE BLOCK ###No support requests per PM! Back to top kolusuSite AdminJoined: 26 Nov 2002Posts: 11548Topics: 74Location: San Jose Posted: Wed Aug 22, 2007 6:48 am Post subject: Quote: 451-System completion code and reason: B37-04 451-Data set is Post a reply Previous topic • Next topic • 9 posts • Page 1 of 1 FTP Space Error by rick walker » Fri Sep 18, 2009 8:12 pm I am

B37-04 Error

When I code: site cyl primary=100 secondary=25 lrecl=80 blksize=0 recfm=fb, I get the following error:500 'SITE recfm=fb lrecl=80 blksize=0 cyl primary=100 secondary=25': command not understoodWhen I don't pre-allocate, it creates the It used to work, but the files were smaller. Hope this helps,d.sch.

When I do an ftp get to brink it back to the mainframe, it's about 1/3 of it's original size and is invalid as a load module. They are sending the file as one hugefield. We were receiving the files just fine, then they stopped, with the error I mentioned. "Bryan Dietz" wrote in message news:... > Are you sure they are logging into Related ...

Hope this helps,d.sch. Name=ckresults (write) Rc=-13 Thank You. The DASD Pool contains 8 volumes, allows files to span 2 volumes, had over 90% free space and the space allocations were available at the time of the run. http://www-01.ibm.com/support/docview.wss?uid=isg1PK41012 Suggest you make sure the pds attribute definitions on both systems are the same.

Until a few days ago, I had no authority towrkactjob and other 'system' commands. thanks for helpsample-logTrace: CFtpControlSocket::FileTransfer()Status: Starting upload of C:\downloads\asdf.zipTrace: CFtpControlSocket::ParseSubcommandResult(0)Trace: FileTransferSubcommandResult()Trace: CFtpControlSocket::SendNextCommand()Trace: FileTransferSend()Trace: CFtpControlSocket::SendNextCommand()Trace: CFtpControlSocket::TransferSend()Command: PORT 10,24,1,36,10,128Trace: CFtpControlSocket::OnReceive()Response: 200 Port request OK.Trace: CFtpControlSocket::TransferParseResponse()Trace: CFtpControlSocket::SendNextCommand()Trace: CFtpControlSocket::TransferSend()Command: STOR asdf.zipTrace: CTransferSocket::OnAccept(0)Trace: CTransferSocket::OnConnectTrace: CFtpControlSocket::OnReceive()Response: 125 Storing We werereceiving the files just fine, then they stopped, with the error Imentioned."Bryan Dietz" wrote inmessage news:...Post by Bryan DietzAre you sure they are logging into your iSeries FTP server???I There should be a log file?I would think there are other errors going on afterUSER and before error.

Name=ckresults (write) Rc=-13

Bryan Dietz 2005-06-03 13:03:56 UTC PermalinkRaw Message two quick ways I can think of are to TELNET to the same address you FTP to.Hopefully you get the 400's signon screen.the other dick scherrer Global moderator Posts: 6308Joined: Sat Jun 09, 2007 8:58 am Hasthanked: 3 times Beenthanked: 90 times Top Re: FTP Space Error by rick walker » Sat Sep 19, B37-04 Error Jim, how would I find this log file?File Format Mode Window Search ExtraHelpDATA BASE UTILITY (DBU)32766Arrival2#5120722012*7408691*PA**20050411*20050406*12*20000*G*GX123W*SCA*LTNV*L*CMA-CGMHUDSON*25*X*K~R4*R*K*47527*GENOA*IT~DTM*140*20050412*2100*LT~R4*L*K*47527*GENOA*IT~DTM*140*20050413*1200*LT~R4*D*D*1001*NEWYORK*US***NY~DTM*140*20050427*2158*LT~R4*E*D*3901*CHICAGO*US***IL~DTM*140*20050505*0030*LT~SE*16*565300338~GE*312*5653~IEA*1*000005653~Thanks - again...KathieThis communication may contain privileged and/or confidential information.It is intended solely for the use 451-data Set Is Out Of Space Notify me of follow-up comments by email.

If so, your allocation isn't enough. Violations are punishable by law.If you received this communication in error, please contact the sender immediately anddestroy the material in its entirety, whether electronic or hard copy. Until a few days ago, I had no authority towrkactjob and other 'system' commands. Confidential,proprietary or time-sensitive communications should not be transmitted via the Internet,because there is no assurance of actual or timely delivery, receipt and/or confidentiality.--This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing

Violations are punishable by law.If you received this communication in error, please contact the sender immediately anddestroy the material in its entirety, whether electronic or hard copy. You ran out of space and hence the job abended. I'veseen that cause some problems, although not specifically on the as400.Usually an X12 file should only contain letters, numbers, and thespecified delimiters. Len Sasso RDC Operations - Systems Administrator CSC 327 Columbia Turnpike Information Technology Infrastructure Services (ITIS) | t: 518.257-4209 | m: 518.894-0879 | f: 518.257-4300 | [email protected] | www.csc.com This is

ravikishorebhat, I think the problem is different. Enter your email address here Advertisement Home About Me Sitemap Contact Me Copyright © 2016 Rui Miguel Feio Send to Email Address Your Name Your Email Address Cancel Post was not I ftp it to a network server in BINARY mode, with an extension of .TXT (that might be wrong).

If ebcdic that might be the answer, or if not andthe file itself is ascii it might be too.

Violations are punishable bylaw.If you received this communication in error, please contact the senderimmediately and destroy the material in its entirety, whether electronic orhard copy. We werereceiving the files just fine, then they stopped, with the error Imentioned."Bryan Dietz" wrote inmessage news:...Post by Bryan DietzAre you sure they are logging into your iSeries FTP server???I If you are not the intended recipient,you are strictly prohibited from disclosing, copying, distributing or using any of thisinformation. If they get toyour 400, then it's a customer issue.

If ebcdic that might be the answer, or if not andthe file itself is ascii it might be too. by ranga_subham » Mon Oct 10, 2011 4:18 pm 7 Replies 1308 Views Last post by dick scherrer Tue Oct 18, 2011 10:37 pm Board index The team • Delete all Confidential, proprietary or time-sensitive communications shouldnot be transmitted via the Internet, because there is no assurance of actualor timely delivery, receipt and/or confidentiality.--This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing KathieThis communication may contain privileged and/or confidential information.It is intended solely for the use of the addressee.

FTP to mainframes is also done in a faster rate by using VB format. Text . . . :#5120722012*7408691*PA**20050411*20050406*12*20000*G*GX123W*SCA*LTNV*L*CMA-CGMHUDSON*25*X*K~R4*R*K*47527*GENOA*IT~DTM*140*20050412*2100*LT~R4*L*K*47527*GENOA*IT~DTM*140*20050413*1200*LT~R4*D*D*1001*NEWYORK*US***NY~DTM*140*20050427*2158*LT~R4*E*D*3901*CHICAGO*US***IL~DTM*140*20050505*0030*LT~SE*16*565300338~GE*312*5653~IEA*1*000005653~Thanks - again...KathieThis communication may contain privileged and/or confidential information.It is intended solely for the use of the addressee. If there are multiple mainframes, there might be differences in their configurations. Jim Franz 2005-06-03 13:09:35 UTC PermalinkRaw Message I see the script is wsftp.

thanks Top Profile Reply with quote mike_n_cleveland Post subject: Re: Problem when uploading to MVS when B37 AbendPostPosted: 2010-02-01 19:31 Offline 500 Command not understood Joined: 2010-02-01 19:19 Posts: Kathie--This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing listTo post a message email: MIDRANGE-L-Zwy7GipZuJhWk0Htik3J/***@public.gmane.orgTo subscribe, unsubscribe, or change list options,visit: http://lists.midrange.com/mailman/listinfo/midrange-lor email: MIDRANGE-L-request-Zwy7GipZuJhWk0Htik3J/***@public.gmane.orgBefore posting, please take a moment to review This means that a fix to this APAR is expected to be delivered from IBM in a release (if any) to be available within the next 24 months. by ganeshj_1983 » Sun Apr 17, 2016 4:18 pm 2 Replies 222 Views Last post by NicC Tue Apr 19, 2016 8:55 pm No space..??

If you are not the intended recipient,you are strictly prohibited from disclosing, copying, distributing or using any of thisinformation. Also, i would not use the .txt extension. They create a uniquiely named file in library Gentran each timethey send. File is deleted. 451 Transfer aborted due to file error.

The file showed up fine. I found this to be the resolution when I received this error when FTPing a dataset from a command line UNIX environment to an MVS mainframe.

© 2017 imagextension.com