Flag Permalink Reply This was helpful (0) Collapse - Interesting ...I've never experienced same with Ghost 2003. I’ve forgotten the exact message but I think it was unhappy about bad sectors. It may be detected but could get an unrecoverable error, which Dell would replace that drive. 0 LVL 5 Overall: Level 5 Storage 1 Message Active today Author Comment by:netbones2007-12-13 I have duly tried to use Norton Ghost 15’s “Copy my hard drive” to create a new hard drive. have a peek at these guys
However there is data and an OS on the disk, though it is formatted with FAT as opposed to NTFS. Apply all those changes to Norton Anti-Virus. And download knoppix, set system boots from CD/DVD and run test and access the drive for data. 0 LVL 4 Overall: Level 4 Storage Hardware 1 Message Expert Comment by:funnyfingers2007-12-13 Of course, I did not have any of the anti-spyware or disk utilities others have mentioned. Source
Just after you press Enter to start the copying process, you see the message: "NTFS error: Encountered BAD used MFT Record - run CHKDSK." The error may include the message, "Error Error E7C3000F: Device \\.\PQV2iSnapShot0 cannot read 4,096 sectors starting at LBA 59,040,664. ALthough my problem was resolved about 2 weeks ago shortly after my previous posting.
What I did was to disconnect my old drive and to connect my new drive to an empty point on the motherboard, not on the same point on the motherboard where Probably want to have a backup before trying, if you are inclined to do so. Taking forever to open a folder, documents, or any programs that you didn't have an issue with before? Education Services Maximize your product competency and validate technical knowledge to gain the most benefit from your IT investments.
I have duly tried to use Norton Ghost 15’s “Copy my hard drive” to create a new hard drive. Norton Ghost Seemed a lot of it was prefetch and temporary internet files ( WHOLE lot of it) which is good news to me, since I disabled prefetch and deleted the temp and I then proceeded with doing the recovery on the only image that I have and everything appeared to go well. http://www.symantec.com/connect/forums/gss251-ghost32-fro-disk-errors-creates-unrestorable-image I've tried TRK, Knoppix, GParted, Acronis, Partition Magic.
The command line for this is: Ghost.exe -ntc- This tells Ghost to clone the data as is, including the fragmentation. The drive failed the tests but it's attempted repair did allow a clone to be made on a new drive and the failed drive was sent off to it's maker.Best of remove ikhlayer.sys 2. The time now is 09:54 PM. -- Mobile_Default -- TSF - v2.0 -- TSF - v1.0 Contact Us - Tech Support Forum - Site Map - Community Rules - Terms of
Urgent Customer Issues If you are experiencing an issue that needs urgent assistance please visit our customer support area: Chat with Norton Support @NortonSupport on Twitter Who's online There are currently https://community.norton.com/en/forums/norton-ghost-hard-drive-copy-ignores-ignore-bad-sectors If you run a backup and tick the box to ignore bad sectors then the backup should be valid, you can verify it to make sure the file is usable. Ghost Encountered An Ntfs Volume With A Log File That Has Not Been Flushed Here are a few steps to help speed it up. Clonezilla Uninstalling Ghost would hopefully remove Ghost-related drivers; if Ghost is part of a larger suite of Symantec apps / utilities that you have installed, then it might seem that uninstalling the
I just saw you mentioned " Should I remove the old defective drive first? More about the author United States Products Threat Protection Information Protection Cyber Security Services Website Security Small Business CustomerOne Products A-Z Services Business Critical Services Consulting Services Customer Success Services Cyber Security Services Education Services It told me that it added 1 sector to the drive's "bad sector table". 3. I then ran a restore using the Ghost image I created in 1 (i.e. The exceptions are two small programs that I had to reinstall, but I managed to avoid the total reinstall of everything that I dreaded.
I was not able to find many answers online, but did after some investigation I began to suspect Blu… Laptops/Notebooks Computer Running Slow? Solution This can be a problem if the source drive contains corrupt files or folders. I know I ran chkdsk immediately before running Ghost (Hey! check my blog Actually not too much experience about M$ windows here.
I tried to schedule a chkdsk session through windows, but it was unable to run the command, and left the dirty flag intact. Then try running another one time image without skipping any bad sectors. I suggest you try the image first before trying a copy drive. If your able to get an image without having to skip any bad sectors then your in a better
Dave DStain Norton Fighter25 Reg: 26-Aug-2010 Posts: 1,900 Solutions: 41 Kudos: 119 Kudos1 Stats Re: Norton Ghost hard drive copy ignores "ignore bad sectors" Posted: 27-Mar-2012 | 5:43AM • Permalink Thanks If you use the -NTC- switch, the target computer will include the fragmentation of the source computer. Do NOT make it an 1:1 copy. Create a SymAccount now!' Error: "NTFS error: Encountered BAD used MFT Record - run CHKDSK" when cloning an NTFS partition TECH106744 January 31st, 2007 http://www.symantec.com/docs/TECH106744 Support / Error: "NTFS error: Encountered
This is what I did and it appears to have corrected Ghost 14's behaviour with my WINXP SP3 C: drive. 1. I ran a full backup with the "Ignore Bad Sectors" Thanks! Get 1:1 Help Now Advertise Here Enjoyed your answer? news Whenever you run a backup using one of the newer Symantec products (since 2006), be aware that Symantec is arrogant enough to assume that you want their backup product running in
If you can't convert maybe fixmbr could do something. 03-19-2010, 07:27 PM #3 IT-Tech TSF Enthusiast Join Date: Oct 2009 Location: Evansville, Indiana, USA Posts: 1,153 OS: All When I did this the system was able to run chkdsk and defrag the system. Urgent Customer Issues If you are experiencing an issue that needs urgent assistance please visit our customer support area: Chat with Norton Support @NortonSupport on Twitter Who's online There are currently Hopefully you can end up with 2 full images: first image that skipped bad sectors second image that has no bad sectors Do it in that order because if your drive
© 2017 imagextension.com